Gas Furnaces: Burner Adjustment and Gas Leaks

Heating your home safely is easy, but it does require homeowners to be aware of certain hazards to avoid. It also is important to keep your home heating and cooling equipment in safe working condition. Perry provides the following tips to help keep you and your family safe.

Gas Furnaces: Burner Adjustment and Gas Leaks

Postby Service » Fri Dec 16, 2011 11:35 am

The flames on the gas burner should be full and steady, with no sputtering and no trace of yellow. To adjust the flame height on the main burners, call a professional service person. To adjust the height of the pilot flame, turn the flame adjustment screw until the flame is from 1 1/2 to 2 inches (3.8 to 5.1 centimeters) high. The adjustment screw is located near the gas valve on the pilot assembly, only if the control has this adjustment feature.

If you suspect leaks around the furnace unit, stir up a mixture of liquid detergent and water. Paint this mixture on the gas supply line along its connections and valves; the soapy water will bubble at any point where there's a leak. If you find a leak, try tightening the leaking connection with a pipe wrench, but be careful not to over tighten the connection. If the pipe connections or valves still leak, call a professional service person.

An oil furnace has an entire new set of the problems from the ones we've just conquered in gas furnaces. Move on to the next section to learn how to clear a blocked fuel line or change an oil filter.
Service
 
Posts: 52
Joined: Mon Jun 28, 2010 12:53 pm

Return to Improve the Safety of your Heater or Furnace



Who is online

Users browsing this forum: No registered users and 1 guest

cron